The shift amount and magnification ratio determined for the front page will be automatically applied to the back page. To set this function, follow the procedure below. The Inner Tray IT is equipped with two exit trays. Selection Screen will be restored. When loading large paper, withdraw the right edge of the Multi-sheet bypass tray to extend it. Select the desired output mode.
|Date Added:||21 September 2008|
|File Size:||28.43 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
For details on positioning originals, see p.
Specify the numbering type, printing position, and pages to print on. The Weekly Timer is a copier management function that shuts down power to the machine on a daily or hourly basis, and can be programmed specifically for lunch breaks, weekends and holidays, or any time the copier pginter not required. Your service representative can set the Job No.
Storing Job Conditions job Memory: T rouble- Section 5: Make setting changes from the Key Operator Mode Screen, as described on the following pages.
If the Key Operator password is not valid, check with your service repre- sentative. For example, if an original is placed in the RADF or on the platen glass in the koica.
Touch to highlight the desired mode key. To set this function, follow the procedure below. Use this function to scan an image, then overlay the image onto each page copied in the job.
Downloads – bizhub – KONICA MINOLTA Europe
Display the Basic Screen for the print job in progress. Tray 3 Withdraw the DB tray. Repeat mode will scan the image area specified by the selected copy size and mode 2 Repeat, 4 Repeat, or 8 Repeatthen arrange the image by specified times in one copy sheet. Select additional copy conditions, as desired.
Storing Job Conditions Job Memory: The Output Mode popup menu will be displayed. Since radiation emitted inside this printer is completely confined within protective konoca and external covers, the laser beam Page 8 Contents continued Advanced Section 7: Follow the procedure below to continue the copying operation.
The copier is initially set to Oblique erase mode.
The Store mode is automatically selected. When the Call for Service Screen is displayed, be sure to pribter your service representative immediately by following the procedure below. Change Ecm Data  E.
If the number of originals exceeds 50, divide them into prrinter not prinnter 50 sheets and load them from the block with the first page. Page 86 Output Mode for Machine with Finisher continued When selecting Staple mode, select the staple position as follows. Main body Exit tray: Prevention of Short Circuit Do not install the copier where it could be splashed with rain water, or water from a tap, to avoid a short circuit.
Action liable to cause minor injury, machine trouble or physical damage. If any setting change is required before proofcopying, touch EXIT to return to the Basic Screen, then change settings, as required.
Original Information Original Information Use the platen glass or document feeder to position originals to copy. The Job Recall Check Screen displays to enable you to review the settings.
The Check Screen will be displayed. Arrange originals in order. In this case, the scanned data still remains in memory.
When selecting Repeat, the Repeat Screen will be displayed.